Floor Polisher is suitable for floor grinding, polishing, maintenance, etc. of marble, mosaic, stone and slate floors. Its 3 hp heavy-duty motor meets the most demanding requirements of any of the above operations.
Your machine is powered by a 3 hp, mono-phase motor, 220 V, 1440 rpm. Five mini v-belts drive the spindle, which is mounted in heavy-duty taper roller bearings to ensure smooth running and long life. The spindle is coupled to the abrasive plate by means of a rubber coupling. The rear wheel assembly is connected to the frame of the machine over a raise-lower device. This enables the operator to balance the machine exactly. You may take your hands off a running machine and it will not wander away but stay where it is. This feature coupled with the front handle control gives excellent control over the operation being performed. The machine has adequate self-weight for all grinding, polishing and buffing applications. The operator need not apply any pressure manually. A spring stand is provided to allow easy and convenient change of abrasives and polishing plates. The electrical cable can be conveniently wrapped onto the cable holder. Central water feeding through the shaft brings the water required for grinding exactly to the right place. The water guard prevents splashing of the entire polishing area. The special cross is mounted on nylon bushes, which prevent metal-to-metal contact and run smoothly even without lubrication. The cross allows water to go through its center. A simple change of four bushes makes the cross like new.
Your machine is provide with one abrasive plate capable of holding three Frankfurt / five Casani / six Triangle abrasives. The abrasive plates are easily interchangeable and you can switch from abrasive to another by simply opening two nuts. One spare plain plate may be kept for any eventuality.
Your machine attains its steadiest performance when the wheel side of the machine frame is kept about 25 to 35 mm lower than the handle side. Generally, if the machine pulls to the left you are advised to lower the rear of the machine frame. In case the machine pulls backward you are advised to raise the rear of the machine frame.
The machine is also available in 5 hp and 7.5 hp three-phase models. These models are suitable where large areas have to be level ground in a short period. Care must be taken to ensure proper electrical connections and earthing of the machine to avoid danger to the operator's life.
- Motor : 3hp mono-phase
- Speed : 300rpm
- weight : 135 kg
- Dim : 850 x 520 x 900mm